Reddit reviews Milescraft 5343 8pc. Drill Center for Dowel and Tenon
We found 5 Reddit comments about Milescraft 5343 8pc. Drill Center for Dowel and Tenon. Here are the top ones, ranked by their Reddit score.
Internal and External Points for marking exact drill locationHollowed Centers Make transfer of one dowel hole to the next simpleZinc plated, steel contructionIncluded components: (2) 1/2" Dowel/Tenon Centers
https://www.amazon.com/Milescraft-5343-Dowel-Center-8-Piece/dp/B0055HPJ22
I've found doweling jigs pretty useless. However, I would recommend getting some doweling pins like these. They make a quick job of lining up the holes.
Milescraft 5343 Dowel and Tenon Center Set, 8-Piece https://www.amazon.com/dp/B0055HPJ22/ref=cm_sw_r_cp_api_clahyb64JPRS0
Anytime you use a jig to create your dowels, I would suggest getting dowel centers as well. They fit in your dowel holes to allow you to precisely mark the other piece that you will be attaching to. Like these:
https://www.amazon.com/Milescraft-5343-Dowel-Center-8-Piece/dp/B0055HPJ22
dowel centers.
https://smile.amazon.com/Milescraft-5343-Dowel-Center-8-Piece/dp/B0055HPJ22/ref=sr_1_1?ie=UTF8&qid=1475080117&sr=8-1&keywords=dowel+centers
not sure how large the logs are but I'd drill a hole in the each side and insert a short length of dowel into each piece to bridge the gap. It will be a bit of a challenge to line the holes up such that outside of the logs stays in alignment once the dowel is inserted. Typically this done by drilling one side and inserting a dowel center so that it can leave a mark on the piece so that you know where to drill. If not wanting to buy one a spot of wet paint, or lipstick or whatever, could be sandwiched between the pieces so that both sides get marked in the same spot. Do your best to drill perpendicular to cut the edge of the logs.