Reddit reviews Weller D550PK 260-Watt/200W Professional Soldering Gun Kit with Three Tips and Solder in Carrying Case
We found 5 Reddit comments about Weller D550PK 260-Watt/200W Professional Soldering Gun Kit with Three Tips and Solder in Carrying Case. Here are the top ones, ranked by their Reddit score.
The Weller D550PK brings professional strength and control to the serious hobbyist, with 2 clear front-facing lights for clarityPistol grip design with easy adjustment fingertip trigger switches between 260-watt and 200-watt settingsHeats up completely in just 6 seconds, transferring heat to the heavy-gauge tin-plated copper tipContains the D550 260W/200W dual-heat gun, 2-wire cord, and basic accessories - a coil of lead-free solder, flux brush, and three tin-plated copper tips for soldering, smoothing, and cutting – all held in a blow molded plastic carrying caseKit contains a D550 soldering gun, a coil of lead free solder and 1 each of soldering, smoothing and cutting tipsReady to use in 6 secondsFingertip trigger allows you to easily select high or low output
I believe that the particular design pictured is made of iron wire and heated in a gas flame. If you want an electrically heated version of that you can probably do this with a high wattage soldering iron like this one.
I would add that you may have a problem with mechanical strength of a formed piece of wire that you are going to be heating and using repeatedly. You will probably want to reinforce it with a high temperature material like a sheet of fiber reinforced magnesium board.
Agree with this - get a good iron (Hakko or a Weller WESD51) and a cheap 858D hot air station if you decide you need that. You're not going to need a hot air station unless you start doing surface mount work. Also +1 on the advice to just get a beefy soldering gun for automotive/big wire stuff, you don't need fancy temperature control for soldering wires on battery terminals or whatever it is you're planning on.
For lead-free solder, I've been using low temperature alloys for surface mount stuff, but I think it is mostly just available in paste form.
Im much better then I was the first time. But still bad.
I have 2.
ECG 60W E69348 with 3 different tips. Using the smallest one I have.
Then Weller soldering Gun D550PK
Those come with a "hot knife" tip in the kit.
https://www.amazon.com/Weller-D550PK-260-Watt-Professional-Soldering/dp/B00002N7S1
Get this
Weller D550PK 260-Watt/200W Professional Soldering Gun Kit with Three Tips and Solder in Carrying Case https://www.amazon.com/dp/B00002N7S1/ref=cm_sw_r_cp_tai_VjDzDbMT8SJD2
And fresh high quality rosin core solder and it’s a piece of cake.