Reddit reviews Zona 35-050 Ultra Thin Razor Saw, 52 TPI.008-Inch Kerf, Blade Length 4-1/2-Inch, Cut Depth 7/16-Inch
We found 2 Reddit comments about Zona 35-050 Ultra Thin Razor Saw, 52 TPI.008-Inch Kerf, Blade Length 4-1/2-Inch, Cut Depth 7/16-Inch. Here are the top ones, ranked by their Reddit score.
Ultra Thin Kerf Razor Saws are the thinnest razor saws available with blades that are onlyCountry Of Origin: United StatesModel Number: 35-050Item Package Dimension: 13.0" L x 3.0" W x 1.5" H
Be careful with this though. The wedge action of clippers when used between the mini's feet will spread the legs a bit, which could cause damage or be difficult to correct, depending on the sculpt.
My go to method is to clip around the edges with clippers, removing as much material as possible without deforming the base. Then I saw an X between the feet with a razor saw and then clip away the rest. Then remove material from around the feet with a file and X-Acto knife.
If you want to get REALLY fancy, you can use a Dremel tool and high-speed cutter bit. But you have to be careful...
Looking good!
Trim looks good.
Few tips from a "metal worker, who attempts to make things out of wood" tranlation, when I have corner gaps I just us a bigger weld bead or saw dust and glue:
Big Box.
Glue in stages. Ya, it will take a few days.
Day One: trial fit everything (you have that down!)
Day One: Glue the two center upright parts with small horizontal part. Top is fitted dry to confirm everything is square.
Day Two: Now the top piece.
Day Three: Now the end pieces.
Did you use wire nails (headless 22g) or the salt trick on the beveled ends? I love gluing up rabbets, but with vaneer panels you need those 45 degree cuts.
Trim Pieces, a small gap is visible. Make a tiny miter box for just small trim and use a a small hand saw
Still on my wish list (new table saw with this blade).
http://www.rockler.com/rockler-miter-fold-dado-set
Keep on building.