Best engine tilters according to redditors
We found 5 Reddit comments discussing the best engine tilters. We ranked the 2 resulting products by number of redditors who mentioned them. Here are the top 20.
We found 5 Reddit comments discussing the best engine tilters. We ranked the 2 resulting products by number of redditors who mentioned them. Here are the top 20.
You can do them without rolling if you have small hands, I use a Thexton419 which is a pretty worthwhile investment if you own one of these cars. I know a lot of people take loose the torque mounts, roll it forward and jam a 2x4 between the block and the firewall, though.
There a tool you can get where you remove the two dogbone motor mounts and install this tool in place of one that has a threaded rod and crank that allows you to roll the engine forward to allow better access to the rear bank.
Thexton 419X GM Engine Moving Tool https://www.amazon.com/dp/B000IHNZPC/ref=cm_sw_r_cp_api_i_FsMQCbC9H5C7M
http://www.amazon.com/Thexton-419X-Engine-Moving-Tool/dp/B000IHNZPC
You unbolt the "dogbone" motor mount(s) on the top of the front of the engine bay and put this in its place. You turn the tool in the move the top of the motor forward. If you get your hands on this tool just make sure you don't pull the motor so far forward that you smash the ac lines into the radiator fan.
I got a 02 ss. I removed the dog bone mounts in front of the engine. Put it in neutral used this tool http://www.amazon.com/Thexton-419X-Engine-Moving-Tool/dp/B000IHNZPC. Much easier.
https://www.amazon.com/OTC-Tools-7011-14-51mm-Ball/dp/B0019M0O2M/ref=sr_1_1?s=automotive&ie=UTF8&qid=1511455950&sr=1-1&keywords=2+inch+ball+hone
Try something like this hone inside of your plates, we used them in the bike shops I worked in to de-burr steel and aluminium seat post tube to prevent gouging the seatpost.